ILX Lightwave LDC-3700 Series User Manual

POINTS OF
INTEREST Disabling the BEEP will prevent the audible beeper signal from working during front panel
operation, including the calibration signals.
The beeper is normally enabled, unless it is specifically disabled via the "BEEP 0" remote
command.
EXAMPLES
"BEEP?" -response: 0, means the beeper is disabled.
"Beep?" -response: 1, means the beeper is enabled for normal operation.
Front Panel
W Remote
DELAY
The DELAY command causes the execution of commands to be delayed by a userdefined time. This
command is similar to the *WAI common command, except that execution resumes after the specified
number of milliseconds, instead of waiting for the Operation-Complete flag to be set.
SYNTAX DLAGRAM
PARAMETERS An <nrfvalue> which represents the delay time, in milliseconds.
POINTS OF
INTEREST
The Operation-Complete flag is held false until the delay period elapses, but the *OPC? query
will not execute until the delay period has elapsed.
This command is
useful for creating delays which don't require a lot of program code and
don't tie up the GPIB during execution.
EXAMPLES
"DELAY 500" -action: Further commands and queries are not executed until 0.5 seconds
have elapsed from the
time this command is executed.
"Tec:T 22;Delay 2000;Tec:TI" -actions: The TEC is set to 22.0°C, then the LDC-3700 Series
Laser Diode Controller
waits for about 2.0 seconds before returning the measured
temperature.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English