Image Access bookeye 3 Assembly Manual

A.2 Assembling the Components
A.2.1 Assembling the Camera Head to the Neck
Take the camera head out of its transport box and place it on a suitable table.
Note: For the following steps, the camera head must be placed with the top side down
on the table.
The cables coming out of the camera head must be inserted into the neck and must be
guided through it.
One end of the neck and the end of the camera head element are cut at a corresponding
angle.
Insert the cables at this end of the neck and push them forward carefully. The cables are
protected by a flexible foam material tube.
Picture 6: Attaching camera neck to camera head
When the cables have been pushed through the upper side of the neck, position the neck
over the fastening angles.
Page 18 Setup and Assembly Manual

Image Access bookeye 3 Specifications

General

Brand	Image Access
Model	bookeye 3
Category	Scanner
Language	English