Version History
Version Published in Content/Changes/Supplements
A November 2005 Preliminary version.
Description of the device elements.
Description of assembling steps.
B January 2006 Preliminary version.
Some changes at the body element base. Order of assembling steps
for the camera neck and camera head has been changed.
C February 2006 Preliminary version.
Chapter added: Scan2Net Firmware Adjustment Procedure.
D February 2006 Preliminary version.
Additional information in chapter Final Mechanical Adjustments.
New: Recovery Function
E April 2006 First Final Edition.
General formatting and several technical changes.
F August 2006
Second Edition: Chapter A.1.2 added.
Chassis A and B introduced. Chapter B2 changed.
dditional information concerning adjustment of the lamps, see
chapter A.2.4.1 to A.2.4.4.
G November 2006 Second Edition: Additional information concerning measurement of
Auto Focus, chapter B.2.2. to B.2.2.2. Differentiation between
Chassis A and Chassis B.
H January 2009
New chassis version.
List of assembling material revised.
Additional information in chapter B.2 Mandatory Optical Adjustments
Renew of some screenshots of the user interface because of new
firmware version.
NOTE:
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and radiate radio frequency energy and, if not installed and used in accordance with the operation
manual, may cause harmful interference to radio communications.
Operation of these equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Setup and Assembly Manual Page 5
To Next Page
Loading...
Need help?
General
