TechDoku_CC1000_VCC1000_CC3000_VCC3000_GenPM_GB_860
25010_86025110.doc
8. Insert the drawing bar into the die (about 8 cm) and tighten the roller.
9. Tighten the metal plate.
10. Install thermocouples.
11. Dip the drawing bar into separating graphite for about 5 cm and let dry
(Graphite spray or Hydrokollag).
12. Open cooling water and compressed air supplies. Turn the mains switch.
13. Set the desired casting program (1 to 99 programs available). Check diame-
ter of drawing roll in your program.
14. Set the pressure draw roll to ~ 2 bars.
15. Rotate the sealing rod into the crucible bottom (rotating movement).
16. Insert the drawing bar into the die for about 1-2 cm and tighten it. Mark the
top position with marker. The safety cylinder will detect that there is a starter bar
inserted.
To Next Page
Loading...
