5 - 11
XTC/3 Operating Manual
5.2.2.3 Standard QUERY Commands
5.2.2.3.1 Query Block
Command:
QB<Command ID>
Command ID = See listing below
Response:
Depends on Command ID. See listing that follows
Command ID = 1 ”All Parameters”
The command will return all parameters in the following order. Formats are
listed in the individual commands. Maximum bytes allowed in the response are
57,800. A Command Length error code L is returned if there is too much data.
Response:
<Number of Bytes in Response><General Parameters><Film 1
Parameters>…<Film32 Parameters><Inputs><Outputs><Output Types><Film
1 Name>…<Film 32 Name> <Process One>…<Process 99><Process 1
Name>…<Process 99 Name>
Number of Bytes in Response (2 bytes)
All General parameters (4 bytes per parameter)
All parameters for each film (4 bytes per parameter) (9 or 32 films based
on XTC/3S or XTC/3M)
All input definitions (9) (1 byte per input) (XTC/3M only)
All output definitions (20) (1 byte per output) (XTC/3M only)
All output types (20) (1 byte per output) (XTC/3M only)
All Film Names (null terminated) (32 films) (XTC/3M only)
Every process layer list for each process (99) (2 byte length (for the number of
layers programmed) followed by 1 byte for each programmed layer) (XTC/3M
only)
All process Names (null terminated) (99) (XTC/3M only)
Command ID = 2 ”All Parameters without Process Layer lists and Process Names”.
Will return all parameters in the following order, with formats as listed in the
individual commands.
To Next Page
Loading...
Need help?
General
