EasyManua.ls Logo

Ingersoll-Rand INSIGHTqc - Running LED Test

Ingersoll-Rand INSIGHTqc
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Torque (Nm)
Dynamic
Torque
value
in
Nm
while
tool
is
running.
Speed (RPM)
Dynamic
Speed
value
in
RPM
while
the
tool
is
running.
Angle (°)
Total
number
of
degrees
of
rotation
while
the
tool
is
running.
Running LED Test
Do
the
following
to
run
a
LED
test:
Under
Tool
Information,
below
LED
Test,
select
Start.
LED
lights
on
the
tool
connected
to
the
Fastening
Controller
starts
blinking
for
5
seconds
and
switches
between
red,
green
and
yellow.
1.
To
stop
the
LED
test,
select
Stop.
2.
To
exit
from
Tools
Diagnostics
-
Run
Diagnostic
screen,
select
Exit
Diagnostics.
At
the
Warning
screen,
select
Yes.
The
Tool
Information
screen
will
be
displayed.
NOTE :
The
tool
I/O
relates
to
handheld
tools
(QE)
and
not
for
fixtured
tools
(QM).
Go
to
top
Close

Table of Contents

Related product manuals