Ingersoll-Rand INSIGHTqc - Torque (Nm); Cycle Results

NOTE : It triggers when angle
achieved is less than the set limit.
NOTE : For a quick identification of results using background
colors in angle (°) area, refer to
Background Colors .
Torque (Nm)
Parameters displayed on the torque (Nm) area are described as follows:
Parameter Description
Torque Force applied to a fastener.
Target Torque
Indicates the target value for the
select configuration if the strategy
is Torque Control. Must be less
than or equal to max torque of the
tool.
(Torque High
Limit)
Indicates torque high limit set for
the configuration.
NOTE: It triggers when torque
achieved is greater than or equal
to the set limit.
(Torque Low
Limit)
Indicates torque low limit set for
the configuration.
NOTE : It triggers when torque
achieved is less than the set limit.
NOTE : For a quick identification of results using background
colors in torque (Nm) area, refer to
Background Colors .
Cycle Results
Parameters displayed on the cycle results area are described as follows:
Parameter Description
PSET
Indicates the Pset assigned for the
current task.
Job Cycle
Incremental number of jobs run by
the controller.