Close
Go
Back
Global
Settings
Perform
the
following
to
update
the
global
settings:
At
the
Job
List
screen,
select
Global
Settings .1.
The
Global
Settings
screen
will
be
displayed.
To
enable
boot
job,
select
the
Boot
Job
field
to
show
indicator
in
ON
position.2.
NOTE :
If
enabled,
boot
job
allows
the
user
to
resume
a
job
that
was
interrupted
by
a
power
cycle/outage
once
the
controller
reboots.
If
disabled,
the
controller
will
consider
the
interrupted job as aborted and will be ready for the next job.
To enable queue barcode, select the Queue Barcode field to show indicator in ON position.3.
NOTE :
If
enabled,
for
the
current
job,
the
current
barcode
will
be
attached
to
all
results
and
any new barcode will be used only after the current job completes. Only one barcode can be
queued
and
will
be
the
latest
barcode
scanned.
If
disabled,
the
controller
will
attach
the
new
barcode scanned to any new results immediately.
From the Curve Logging field, select a curve logging type from the drop down list:4.
NOTE :
All
traces
will
be
displayed
on
the
home
screen.
This
section
is
for
the
storage
of
trace data for retrieval from the cycle results screen only.
None:
Traces
are
not
stored
in
the
database.x
All:
Traces
are
stored
in
the
database
and
can
be
viewed
on
the
cycle
results
screen.x
Bad only: Traces from failed cycles will be stored and can be viewed from the cycle
results screen.
x
From
the
Job
Selection
field,
select
a
job
type
from
the
drop
down
list:
5.
Internal : User can select the job to run from the home screen through the job
select
dropbox.
x
External
-
MES:
System
will
only
allow
job
selection
from
external
MES
systems.x
External
-
Barcode :
System
will
only
allow
job
selection
from
scanning
of
a
barcode.x
External
-
Discrete :
System
will
only
allow
job
selection
from
the
discrete
inputs
where
there
is
a
one
to
one
correspondence
between
the
input
and
the
job
that
are
programmed.
x
External
-
Discrete
-
Field
Bus:
System
will
only
allow
job
selection
from
the
Fieldbus
inputs
where
there
is
a
one
to
one
correspondence
between
the
input
and
the
job
that
are
programmed.
x
External
-
Binary :
Based
on
the
pin
configuration,
the
respective
job
will
be
selected.
Whereas,
in
External
-
Descrete
job
selection,
each
pin
is
responsible
for
single
job
selection.
x
To Next Page
Loading...
