Close
Go
Back
EOR
Data
Out
EOR
Data
Out
is
a
communication
protocol
that
gives
end
of
run
data
in
a
configurable
format.
This
format is easily integrated with MES and data collection systems. The EOR data is transmitted
through
USB-Serial
or
Ethernet
interface
in
ASCII
text
format.
To
enable
EOR
Data
Out,
select
the
Enable
field
to
show
indicator
in
ON
position.
To
enable
logs,
select the Enable Logs field to show indicator in ON position.
Selecting
a
Source
Do
the
following
to
enable
EOR
data
out:
Under
Select
Source,
select
one:1.
Ethernet :
Data
will
be
communicated
through
the
Ethernet
port.a.
Serial :
Data
will
be
communicated
over
a
serial
connection
using
a
serial
to
USB
converter.
b.
If
Ethernet
is
selected,
do
as
follows
(else,
move
to
step
6):2.
In
the
Port
No
field,
enter
the
port
number.
a.
NOTE :
Default
port
number
is
1069.
In the Job ID field, enter a 4 digit job number to uniquely identifies the controller.3.
From
the
Delimeter
field,
select
one
from
the
drop
down
list:4.
Comma
(,)x
Semi-colon
(;)x
Colon
(:)x
From
End
of
Record
field,
select
one
from
the
drop
down
list:5.
Null: This is a Null character placed at the end of the message to let
the system know
the message is complete.
x
CR: This is a Carriage Return character placed at the end of the message to let the
system know the message is complete.
x
LR:
This
is
a
Line
Feed
character
placed
at
the
end
of
the
message
to
let
the
system
know
the
message
is
complete.
x
CR/LF :
This
is
a
Carriage
Return
character
followed
by
a
Line
Feed
character
placed
at
the
end
of
the
message
to
let
the
system
know
the
message
is
complete.
x
If
Serial
is
selected,
do
as
follows:6.
To Next Page
Loading...
