or
OFF
position.
NOTE : This can be enabled only when Handheld tools are configured to be in handheld
mode.
A
handheld
tool
in
machine
mount
mode
cannot
have
tubenut
enabled.
When
Enable
Tubenut
is
ON,
normal
reverse
operation
of
the
tool
is
disabled.
If
indicator
is
ON,
from
the
Tubenut
Operation
Mode
field,
select
from
the
drop
down
list:a.
Tubenut 0 (Default): In this mode, using the direction switch will place the tool in
reverse direction. When the trigger is pulled, tool will run in reverse direction.
x
Tube Nut 1 (Momentary) : In this mode, the tool will run in tubnut reverse direction
when the momentary switch is activated.
x
Tube
Nut
2
(Momentary
+
trigger) :
In
this
mode,
the
tool
will
run
in
tubnut
reverse
direction
when
momentary
switch
and
trigger
are
activated
simultaneously.
x
Tube
Nut
3
(Trigger
only):
In
this
mode,
the
tool
will
run
in
forward
direction
on
pulling
the
trigger.
When
the
trigger
is
released
and
pulled
again,
the
tool
will
run
in
tubnut
reverse
direction.
Sequence
of
the
tool
running
in
forward
or
reverse
direction
will
change
when
the
trigger
is
pulled
and
released.
x
If
indicator
is
OFF,
from
the
Programmable
Switch
field,
select
from
the
drop
down
list:b.
None:
Activating
the
switch
will
have
no
effect
on
the
system.x
Batch
Advance :
After
a
failed
cycle,
the
user
can
use
the
momentary
switch
to
skip
that
fastener
and
advance
the
batch
count.
x
Batch
Reset :
Resets
the
count
at
0.
Indicates
that
the
user
will
start
over.x
Job Reset : When momentary switch is activated, the controller will reset to the first
fastener of the
first PSETof the selected job. This indicates that the user has decided to
start over the job.
x
To
enable
tact
alert,
select
the
Enable
Tact
Alert
field
to
show
indicator
in
ON
position.5.
NOTE :
This
alert
can
be
enabled
for
handheld
tools
only.
Enabling
Tact
alert
causes
the
tool
to
vibrate
after
a
failed
cycle.
Select
Save.6.
Go
to
top
Close
To Next Page
Loading...
