Ingersoll-Rand INSIGHTqc - Page 45

torque drops below then rises above the threshold torque.
To save the advance step settings for torque step, select Ok.8.
Select Save.9.
Do the following to define settings for angle step:
At Flags, select
to view the contents:1.
Select if applicable:a.
EOR Data Enable : If enabled, system will provide EOR message at the completion of
tightening strategy.
x
Torque Threshold Enable :If enabled, includes cycle below torque threshold value.x
At Speed (RPM), select
to view the contents:2.
In the Free Speed field, enter a value at which the tool will run before reaching the
Torque Shift down Point.
a.
In the Shift down Speed field, enter a value at which the tool will run after reaching
Torque Threshold for Shift down.
b.
At Angle (°), select
to view the contents:3.
In the Target field, enter a torque value required to be achieved for the fastening. a.
In the High Limit field, enter a value for high limit that a fastener can turn past the torque
threshold point; beyond which the tool will automatically stop.
b.
In the Low Limit field, enter a value for low limit that a fastener can turn past the torque
threshold
point; beyond which the tool will automatically stop.
c.
In the Overshoot Compensation field, enter a value that will be subtracted from the Angle
Target to compensate for any overshoot.
d.
At Torque (N m), select
to view the contents:4.
In the High Limit field, enter a value for the maximum acceptable limit.a.
In the Low Limit field, enter a value for the minimum acceptable limit.b.
In the Threshold field, enter a torque value at which the tool will start counting angle.c.
In the Downshift Threshold field, enter a torque value at which the tool slows-down to the
downshift speed.
d.
At Yield field, select
to view the contents:5.
Select if applicable:a.