Close
Go
Back
Cycle
Results
This
screen
provides
detailed
results
from
each
fastening
performed
by
the
tool
connected
to
that
controller. Filters are added to allow the user to easily search through the data to view specific
records.
Columns
can
be
customized
based
on
user
requirements.
Parameters
displayed
on
the
cycle
results
screen
are
described
as
follows:
Parameter Description
Cycle Pass/Fail
Indicates the overall pass/fail
status of the fastening that
generated the fastening results.
Measured
Torque
Maximum value of torque
achieved during fastening.
Date
&
Time
Date and time of completing the
fastening operation.
Torque
Result
Torque result is 'High Torque'
failure, if the value of torque
exceeds the maximum torque limit.
Torque result is 'Low Torque'
failure, if the value of torque is
below the minimum torque limit.
Otherwise, the Torque result is a
Pass.
Angle Result
Angle result is 'High Angle' failure,
if the value of angle exceeds the
maximum angle limit. Angle result
is 'Low Angle' failure, if the value
of angle is below the minimum
angle limit. Otherwise, the Angle
result is a Pass.
Measured/Peak
Angle (°)
Maximum value of angle achieved
during fastening.
Reason
for
Shutdown
Indicates the cause for cycle abort
or termination.
Spindle
Cycle
Number
Incremental
number
of
fastenings
performed
by
the
connected
tool.
To Next Page
Loading...
