GA02118 User Manual BV20
<< Back to Contents
Copyright © Innovative Technology Ltd 2018 Doc: GA02118/1 User Manual BV20
Version: 1.0
Page 14 of 60
4 SOFTWARE INSTALLATION AND CONFIGURATION
4.1 Introduction
The BV20 leaves the factory pre-programmed with the latest dataset and firmware
files. However, it is important to ensure your device is kept up to date with the latest
dataset and firmware. This section will give you a brief overview of the various
update possibilities with the BV20. For detailed instructions please refer to the
relevant manual package supplied with the software or contact support@innovative-
technology.com.
4.2 Software Downloads
All software from Innovative Technology Ltd is free of charge and can be
downloaded from the website www.innovative-technology.com/support/secure-
download once registered and logged in. If you are not registered, please create an
account via the Create an account form. A confirmation email will be sent to the
registered email address once all contact details have been successfully submitted.
4.3 Drivers
The ITL drivers allow you to connect any of our validators to a compatible Windows
device. If you are connecting via an IF17 then you will not need to follow this
process as they are signed Microsoft Drivers and should install automatically. If this
isn’t the case or your computer is disconnected from the network, there is a
standalone package included within the driver downloads.
4.4 Dataset/Firmware Programming
4.4.1 Validator Manager
4.4.1.1 General Description
Validator Manager is a utility which allows the user to reprogram any of ITL’s
validators, hoppers as well as coin and note recycler. Please note that admin rights
are required during installation. The validator must be in SSP for the Validator
Manager to detect the device.
4.4.1.2 System Requirements
• Windows XP SP3 or above
• .Net Framework 4
• 256mb ram
• 50mb hard disk free
• Connected BV20 with active com port
We have seen instances where one
of the dll’s (itdata1.dll) used in
Validator Manager are flagged as a
Trojan, this is a false positive and if
this happens you will need to add a
rule to your antivirus to allow the
file to run.
To Next Page
Loading...
