GA02118 User Manual BV20
<< Back to Contents
Copyright © Innovative Technology Ltd 2018 Doc: GA02118/1 User Manual BV20
Version: 1.0
Page 47 of 60
8.3 Clearing a Checksum Error
According Flash Codes Table, some LED's flashing may indicate CHECKSUM errors. It
may happen when, during comparing, validator's checksum does not match with
original file's one after some manipulations (updating, repairing, etc.).
In this case, reprogram validator using Validator Manager program as described in
4.4.1.5 section. Test validator with several different banknotes after error is emoved.
If error persists, use another Dataset file for downloading to localize problem reason.
If error is not disappearing, use EEPROM downloader software.
Please, contact support@innovative-technology.com for details.
To Next Page
Loading...
