Inovytec Ventway Sparrow User Manual

Ventway Sparrow User Manual
Page 123 of 144
23.5. LOW PEEP
Step Procedure Action Expected Results
1 Start up the Sparrow ventilator.
Complete the patient circuit test.
The software switches to the ventilation phase,
weight selection screen.
2 Set the simulator to the patient weight of
60 kg. Select 60 kg and then SIMV
ventilation mode, Invasive/Non-Invasive,
and confirm the patient connection.
Mode is set. The blower starts.
The software switches to running ventilation, in
SIMV mode.
3 Go to menu -> alarm settings, change
PEEP to 10 (this appears in the second
page of the alarm settings).
Go back to run screen.
See the run screen.
4 Decrease PEEP below the limit. See
Section
15.7. Setting the PEEP Value for
instructions for setting the PEEP.
See that the peep drops to about 5 on the run
screen
5 Wait a few seconds See that a “low peep” warning pops-up, with an
option to cancel and to confirm.
6 Press cancel See that the pop-up disappears.
7 Select to view active alarms via the
menu.
Alarm is shown.
8 Increase PEEP.
See Section 15.7. Setting the PEEP Value
for instructions for setting the PEEP.
See that the PEEP rises to about 10 on the run
screen
9 Select to view active alarms via the
menu.
Alarm is not shown.
10 Decrease PEEP below the limit. See
Section
15.7. Setting the PEEP Value for
instructions for setting the PEEP.
See that the PEEP drops to about 5 on the run
screen
11 Wait a few seconds See that a “low peep” warning pops-up, with an
option to cancel and to confirm.
12 Press confirm See that the pop-
up disappears and that the
alarm disappears from the alarms screen.
13 Select to view active alarms via the
menu.
Alarm is not shown.

Inovytec Ventway Sparrow Specifications

General

Brand	Inovytec
Model	Ventway Sparrow
Category	Medical Equipment
Language	English