Intermec EasyCoder PF4i User Manual

Chapter
12
—
Adjustments
LTS
(Label
Taken
Sensor)
ThesensitivityoftheLTSmayneedtobeadjustedaccordingtoambi-
entlightconditionsandre
fl
ectivecharacteristicsofthebacksideofthe
media.ThisisdoneintheSetupMode(PrintDefs/LTS),seeChapter7.
YoucanalsocheckthattheLTSworksproperly.
TheLTSsetupoptionsareonlydisplayedifanoptionallabeltaken
sensorisinstalledintheprinter.
LTS Adjust
Press<Enter>.Alabelisfedout.Removethelabelandpress<Enter>
again.Amenushowsthesensitivityautomaticallyselectedbythe
fi
rm-
wareandtherange,inwhichtheLTSwillwork.Press<Enter>againand
youwillproceedtotheLTSTestmenu.
LTS Test
Press<Enter>.Alabelisfedout.Removethelabelandanewlabel
shouldbefedoutautomatically.RepeatuntilyouaresuretheLTSworks
properly.Thenpress<Enter>tostopandexit.
LTS Value
Press<Enter>.Youcanenteranewvalueintherangeindicatedinthe
LTSAdjustmenu(seeabove).Min/maxvaluesareintherange0to10.
114

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g