Intermec EasyCoder PF4i - Self-Adhesivelabels

Appendix
B
—
Media
Speci
fi
cations
Self-Adhesive
Labels
⇐  ⇒    
Maximum:
Minimum(standard):
Min.(narrowQuick-Load):
Min.(wideQuick-Load):
⇐  ⇒ 
Thebackingpapermustnotextendmorethanatotalof1.6mm(0.06
inches)outsidethelabelsandshouldprotrudeequallyonbothside.Rec-
ommendedminimumtransparency:40%(DIN53147).
⇐  ⇒    
Maximum:
Minimum:
⇐  ⇒  
Maximum:
Minimum:
Underidealcircumstances,aminimumlabellengthof4mm(0.16
inches)couldbeused.Itrequiresthesumofthelabellength(d)andthe
labelgap(e)tobelargerthan7mm(0.28inches),thatbatchprintingis
used,andthatnopullbackofthemediaisperformed.Intermecdoesnot
guaranteethatsuchshortlabelswillwork,butitisuptotheusertotest
thisinhisuniqueapplication.
⇐  ⇒  
Maximum:21.3mm(0.83inches)
Recommended:3.0mm(0.12inches)
Minimum:1.2mm(0.05inches)
TheLabelStopSensormustbeabletodetecttheextremefrontedgesof
thelabels.Itcanbemovedbetween5
fi
xedpositions(seeChapter12).
Media Type Setup
·Label(wgaps)