Chapter 2 — Connecting the SF61B
SF61 Cordless Scanner User’s Guide 27
To test the Bluetooth communication
1 Open a data input application on the Intermec computer (Start >
Text for example).
2 Read the following test code to make sure your connection is
working correctly:
Code 39 Test Bar Code
*123456*
*123456*
Disconnecting the SF61B from an Intermec Computer
This procedure tells you how to disconnect your SF61B cordless
scanner from a recent Intermec computer running Windows CE.
To remove the SF61B from the Intermec computer
1 Tap Start > Settings > System > Wireless Scanning > Remove
Device > Remove.
The SF61B emits the “disconnect successful” beep sequence (series
of beeps from high to low) and the Intermec Ready-to-Work
indicator goes off.
2 Tap Finish to exit the disconnect procedure.
Note: The following procedure is valid for recent Intermec computers.
If your Intermec computer has a different interface to the one
described here, the general principle will be the same.
Refer to the product-specific documentation for your Intermec
computer for full details on how to disconnect Bluetooth devices from
your product.
To Next Page
Loading...
Need help?
General
