Chapter 3 — Configuring the SF61B Cordless Scanner
SF61 Cordless Scanner User’s Guide 57
Configuring your Scanner From Your Intermec
Computer
You can configure many settings for the SF61B from your Intermec
computer using Intermec Settings.
To Configure the SF61B from Your Intermec Computer
1 Establish a Bluetooth connection with your Intermec computer
(see Connecting the SF61B to an Intermec Computer in
Chapter 2).
2 On your Intermec computer, start the Intermec Settings
application which may be located in Settings > System folder
depending on your Intermec computer.
3 Select Data Collection > SF61 Scanner BDA, where BDA is the
Bluetooth Device Address (BDA) of your SF61B. The SF61B
Bluetooth address is located on the label of your SF61B, see SF61B
Bluetooth Device Address Location in Chapter 2.
4 Configure commands from the SF61 Scanner menu for your
SF61B.
5 Select File > Save Settings. The SF61B is updated with the new
configuration command settings.
6 Close Intermec Settings.
Note: The description in this section is provided as a general
guideline. Consult your Intermec computer’s documentation for full
details on how to set up your Bluetooth scanner from your Intermec
computer.
Note: When you first connect to an Intermec computer, only SF61B
settings common to the Intermec computer’s internal scanner settings
are changed to the internal scanner’s default settings.