Chapter 1 — Introducing the SF61B Cordless Scanner
12 SF61 Cordless Scanner User’s Guide
Using Vibrate Alert
You can configure the SF61B to vibrate when it successfully decodes a
bar code. This feature can be useful in these situations:
• You are in a noisy environment, such as a busy warehouse, where it
can be difficult to hear the beeps.
• You are working in a quiet environment, such as a library, where
you do not want to make a lot of noise.
Two fast beeps The scanner successfully scanned a configuration bar
code
Two beeps, bitonal The scanner is docked correctly in a battery charger.
Six very fast beeps
and vibrate alert
Transmission error
or
Configuration bar code was not accepted
Series of beeps
from low to high
The scanner is connecting to a Bluetooth host.
Series of beeps
from high to low
(cannot be
deactivated)
The scanner is disconnecting from a Bluetooth host.
Note 1: The scanner does not beep when disconnecting
automatically after a long period of inactivity.
Note 2: The scanner performs a hardware reset (restart)
when it is disconnected from EasySet (two beeps and a
vibrate alert by default).
Six-beep melody
(cannot be
deactivated)
Scanner confirmation after rescue procedure (see in
Chapter 4).
Default SF61B Beep and Vibrate Alert Descriptions
Beep Sequence What it Means
Note: You can use EasySet to modify the default vibrate alert settings
if you wish (Operating settings > Beeps / LEDs > Vibrate alert).
In this Manual and in EasySet, default settings are indicated by "(*)"
after the name of the default setup command.
To Next Page
Loading...
Need help?
General
