Chapter 2 — Connecting the SF61B
SF61 Cordless Scanner User’s Guide 33
The host searches for all active Bluetooth devices within range.
Your SF61B scanner appears in the Bluetooth device list with the
name SF61B - BDA, where BDA is the scanner’s Bluetooth Device
Address.
5 Select your scanner in the list and click Next (or the equivalent
command).
Note: If a pairing code is requested, click Enter the device’s
pairing code (or the equivalent command), enter the scanner’s
pairing code (the default Intermec Bluetooth pairing code is
“0000”) and confirm.
Your SF61B scanner is now displayed in the host PC’s list of paired
devices.
If You have Paired Using the HID Profile
Your SF61B is paired and connected to the host - you hear the
“connection successful” beep sequence (series of beeps from low to
high) and see the Intermec Ready-to-Work indicator (continuous
blue by default).
If You have Paired Using the SPP Profile
Your SF61B is paired but not connected to your host application -
you will not hear the “connection successful” beep sequence (series
of beeps from low to high) or see the blue Intermec Ready-to-Work
indicator (default scanner behavior) until you connect to your
host application.
Two Bluetooth virtual serial ports have been created (Outgoing
and Incoming).
Note: If the scanner does not appear in the list, it might already be
paired with the host (under some operating systems, already-
paired Bluetooth devices do not appear in the Bluetooth device
search list).
It may also be switched off and therefore not visible to the host,
press the scan button to restart the scanner.
To Next Page
Loading...
Need help?
General
