Chapter 2 — Connecting the SF61B
40 SF61 Cordless Scanner User’s Guide
to low), and the blue Intermec Ready-to-Work indicator blinks
slowly for 5 minutes to indicate it is waiting to connect (default
scanner behavior).
When you open the Incoming COM port again, if the scanner is
switched on it will reconnect to the host application.
Note: Using the Bluetooth Device Disconnect bar code to
disconnect your scanner will disconnect it permanently - it will not go
into the “waiting to connect” state (no blinking blue light) and you
will have to read the hosts’s association bar code label again to re-
establish the connection.
Bluetooth Device Disconnect
To Next Page
Loading...
Need help?
General
