Interroll MultiControl - 5.11 Specific parameters (only Transfer and HPD) in the I;O device

Troubleshooting
Version 3.0 (08/2018)
Translation of original instruction manual 55
No.
Short text
Comment
93
ApplErrMotorVoltage
Voltage error: Motor voltage is missing
94
ApplErrOvcOverloaded
Overload of the brake chopper resistor
95
ApplErrRemoteEmergency
Emergency stop from the transfer neighbour
101
ApplErrInvalidStateTblConf
Error while loading the application program
102
ApplErrNewStateTable
New application program loaded
103
ApplErrInvalidErrConf
Invalid configuration for the selected application
program
104
ApplErrInvalidTeachParams
Invalid parameters for teach-in procedure
105
ApplErrPapSaveConfig
Saving the connection settings of the
neighbourhood communication is not possible
106
ApplErrPapReadConfig
Reading the connection settings of the
neighbourhood communication is not possible