INVT Goodrive 200 - Page 160

Goodrive200 inverters Basic operation instruction
159
Function
code
Name Detailed instruction of parameters
Default
value
frequency)
28:Counter reset
29:Torque control prohibition
30:ACC/DEC prohibition
31:Counter trigger
32:Length reset
33:Cancel the frequency change setting
temporally
34:DC brake
35:Shift the motor 1 into moor 2
36:Shift the command to the keypad
37:Shift the command to the terminals
38:Shift the command to the
communication
39:Pre-magnetized command
40:Clear the power
41:Keep the power
42~63:Reserved
P05.10
Polarity selection of the
input terminals
0x000~0x1FF 0x000
P05.11 ON-OFF filter time 0.000~1.000s 0.010s
P05.12 Virtual terminals setting
0:Virtual terminals is invalid
1:MODBUS communication virtual
terminals are valid
0
P05.13
Terminals control running
mode
0:2-wire control 1
1:2-wire control 2
2:3-wire control 1
3:3-wire control 2
0
P05.14 S1 terminal switching-
on
delay time
0.000~50.000s 0.000s
P05.15 S1
terminal switching-off
0.000~50.000s 0.000s