INVT Goodrive 200 - Page 195

Goodrive200 inverters Fault tracking
194
8.6.6 Overheat of the inverter
8.6.7 Stall during the acceleration of the motor
Speed loss occurs to the
inverter during ACC
Check if the ACC time
is too short
If the it is the inverter
fault or interference,
please contact with our
company
Overcurrent
If the it is the inverter
fault or interference,
please contact with our
company
Check if it performs
parameter autotune
Modify the torque boost
Check if the torque
boost is too high
  
Check if the motor is
special
Reduce the inertia of the
load and increase the
capacity of the inverter
Check if it is V/F
control
Contact with our
company
Check if the load
torque is too big
Thicken the motor cables and shorten
the configuration distance and adjust the
voltage of the reactor
Check if the load and
inertia is too big
Increase the ACC time
Check if the voltage between the
terminals is among the range
Reduce the torque of the
load and increase the
capacity of the inverter
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o
Y
e
s
N
o