INVT Goodrive 200 - Page 80

Goodrive200 inverters Function codes
79
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
7:Frequency degree test FDT2
8:Frequency arrival
9:Zero speed running
10:Upper limit frequency arrival
11:Lower limit frequency arrival
12:Ready for operation
13:Pre-magnetizing
14:Overload pre-alarm
15: Underload pre-alarm
16:Completion of simple PLC step
17:Completion of simple PLC cycle
18:Setting count value arrival
19:Defined count value arrival
20:External fault valid
21:Length arrival
22:Running time arrival
23:MODBUS communication virtual terminals output
24~26: Reserved
27: Auxiliary motor 1
28: Auxiliary motor 2
29~30: Reserved
P06.05
Polarity
selection of
output
terminals
The function
code is used to set the pole of the
output terminal.
W
hen the current bit is set to 0, input terminal is
positive.
W
hen the current bit is set to 1, input terminal is
negative.
BIT0 BIT1 BIT2 BIT3
Y HDO RO1 RO2
Setting range:00~0F
00 ○
P06.06
Y
T
he function code defines the corresponding delay
0.000s
○