INVT Goodrive 35 Series User Manual

Goodrive35 inverters Basic operation instruction
213
Set
value
Function
Instructions
7
Fault reset
External fault reset. It has the same function with the
reset function of STOP/RST on the keypad. This
function can realize remote fault reset.
8
Operation pause
The inverter decelerates to stop. But all running
parameters are in the memory state. For example,
PLC parameters, traverse parameters and PID
parameters. After the signal disappears, the inverter
will come back to the state before stopping.
9
External fault input
When the external fault signal is sent to the inverter,
the inverter will report the fault and stop.
10
Frequency setting up(UP)
This parameter is used to modify the increasing and
decreasing command during the external terminal
given frequency.
Frequency increasing/decreasing setting clear
terminal can cancel the assistant channel frequency
set by the internal UP/DOWN of the inverter to make
the given frequency restore to the frequency given by
the main given frequency channel.
12
Frequency setting
down(DOWN)
12
Frequency
increasing/decreasing setting
clear
13
Switch between A setting and
B setting
This function can realize the shifting between the
frequency setting channels.
The 13
th
function can realize the shifting between A
frequency given channel and B frequency given
channel.
The 14
th
function can realize the shifting between A
frequency given channel and the combination setting
channel set by P00.09
14
Switch between A setting and
combination setting
15
Switch between B setting and
combination setting
www.barghmaher.ir

INVT Goodrive 35 Series Specifications

General

Brand	INVT
Model	Goodrive 35 Series
Category	Inverter
Language	English