INVT Goodrive 35 Series - Page 215

Goodrive35 inverters Basic operation instruction
214
Set
value
Function
Instructions
The 15
th
function can realize the shifting between B
frequency given channel and the combination setting
channel set by P00.09
16
Multi-step speed terminal 1
The 16 stage speeds can be set by the combination of
digital state of four terminals.
Note: multi-step speed 1 is the low bit; multi-step
speed 4 is the high bit.
Multi-step
speed 4
Multi-step
speed 3
Multi-step
speed 2
Multi-step
speed 1
BIT3
BIT2
BIT1
BIT0
17
Multi-step speed terminal 2
18
Multi-step speed terminal 3
19
Multi-step speed terminal 4
20
Multi-step speed pause
Shield the multi-step speed selection terminal function
to keep the setting value at the current state.
21
ACC/DEC time selection 1
Select 4 ACC/DEC time by the combination of the 2
terminals.
Terminal
1
Terminal
2
ACC/DEC time
selection
Corresponding
parameter
OFF
OFF
ACC/DEC time 1
P00.11/P00.12
ON
OFF
ACC/DEC time 2
P08.00/P08.01
OFF
ON
ACC/DEC time 3
P08.02/P08.03
ON
ON
ACC/DEC time 4
P08.04/P08.05
22
ACC/DEC time selection 2
23
Simple PLC stop reset
Restart simple PLC and clear the memory state of
PLC.
24
Simple PLC pause
Program pause during PLC implement. Run at the
current speed stage. After cancel the function, simple
PLC continues to run.
25
PID control pause
Temporal PID invalid and the inverter will output at the
current frequency.
26
Traverse pause (stop at the
current frequency)
The inverter will stop at the current output and after
canceling the function, the inverter will continue to
traverse run at the current frequency.
27
Traverse reset (return to the
The setting frequency of the inverter will come back to
www.barghmaher.ir