INVT Goodrive 35 Series - Page 219

Goodrive35 inverters Basic operation instruction
218
Function
code
Name
Detailed instruction of parameters
Default
value
P05.08
S8 terminals function
selection
13:Shift between A setting and B setting
14:Shift between combination setting
and A setting
15:Shift between combination setting
and B setting
16:Multi-step speed terminal 1
17:Multi-step speed terminal 2
18:Multi-step speed terminal 3
19:Multi- step speed terminal 4
20:Multi- step speed pause
21:ACC/DEC time 1
22:ACC/DEC time 2
23:Simple PLC stop reset
24:Simple PLC pause
25:PID control pause
26:Traverse Pause(stop at the current
frequency)
27:Traverse reset(return to the center
frequency)
28:Electronic gear selection
29:Torque control disabling
30:ACC/DEC disabling
31:Pulse ascending
32:Pulse descending
33:Cancel the frequency change setting
temporarily
34:DC brake
35:Shift the motor 1 into motor 2
36:Shift the command to the keypad
37:Shift the command to the terminals
38:Shift the command to the
communication
39:Pre-magnetized command
40:Comsumption power clear
41: Consumption power holding
0
P05.09
HDI terminal function
selection
0
www.barghmaher.ir