Set the operation mode of the terminals control
0:2-wire control 1, comply the enable with the
direction. This mode is widely used. It determines
the rotation direction by the defined FWD and REV
terminals command.
1:2-wire control 2; Separate the enable from the
direction. FWD defined by this mode is the enabling
ones. The direction depends on the state of the
defined REV.
2:3-wire control 1; Sin is the enabling terminal on this
mode, and the running command is caused by FWD
and the direction is controlled by REV. Sin is
natural closed.
To Next Page
Loading...
