IP-COM Pro-6-IW - Page 19

Version V1.0
12
Parameter description
Parameter
Description
System Status
Device Name
It specifies the name of the AP.
A unique AP name helps quickly identify the AP. You can
change the AP name on the LAN Setup page.
Uptime
It specifies the time that has elapsed since the AP was
started last time.
System Time
It specifies the current system time of the AP.
Firmware Version
It specifies the firmware version of the AP.
Hardware Version
It specifies the hardware version of the AP.
Number of Wireless Clients
It specifies the number of wireless clients currently
connected to the AP.
LAN Port Status
MAC Address
It specifies the physical address of the LAN port of the
AP. If you connect the AP to other devices using Ethernet
cables, the AP uses this MAC address to communicate
with those devices.
IP Address
It specifies the IP address of the AP and it is also the
management IP address of the AP.
The web UI of the AP is accessible by visiting this IP
address. You can change the IP address on the LAN
Setup page.
Subnet Mask
It specifies the subnet mask of the IP address of the AP.
Primary DNS
It specifies the primary DNS server of the AP.
Secondary DNS
It specifies the secondary DNS server of the AP.