IP-COM Pro-6-IW - Access Control; Overview; Configure Access Control

Version V1.0
57
6.6 Access Control
6.6.1 Overview
The access control function enables you to allow or disallow the wireless devices to access
the wireless network of the AP based on their MAC addresses.
To access the page, choose Wireless > Access Control.
The AP supports the following two filter modes:
− Whitelist: It indicates that only the wireless devices with the specified MAC
addresses can access the wireless networks of the AP.
− Blacklist: It indicates that only the wireless devices with the specified MAC
addresses cannot access the wireless networks of the AP.
6.6.2 Configure Access Control
1. Choose Wireless > Access Control. Select a wireless network radio band on which access
control is to be implemented.
2. From the SSID drop-down list box, select an SSID of the wireless network to which the
rule applies.
3. Enable Access Control.
4. Set Mode to Blacklist or Whitelist.
5. Enter the MAC address of the wireless device to which the rule applies. Then click Add.
Tip
If the wireless device to be controlled has connected to the AP, click Add Online Devices to quickly add the
MAC address of the device to the access control client list.
6. Click Save.