APs are required in the network.
If Address Type is set to DHCP (Dynamic IP Address), you can log in to the web
UI of the AP only with the IP address assigned to the AP by the DHCP server. The
IP address is specified on the client list of the DHCP server.
It specifies the IP address of the AP. The web UI of the AP is accessible at this IP
address.
It specifies the subnet mask of the IP address of the AP.
It specifies the gateway IP address of the AP.
Generally, set the gateway IP address to the LAN IP address of your LAN router
connected to the internet, so that the AP can access the internet.
It specifies the primary DNS server of the AP.
If your LAN router connected to the internet provides the DNS proxy function,
this IP address can be the LAN IP address of the router. Otherwise, enter a
correct DNS server IP address.
It specifies the IP address of the secondary DNS server of the AP. This parameter
is optional.
If a DNS server IP address in addition to the IP address of the primary DNS
server is available, enter the additional IP address in this field.
It specifies the name of the AP.
You are recommended to change the name of the AP to indicate the location of
the AP (such as Bedroom), so that you can easily identify the AP when managing
many APs.
It specifies the Ethernet mode of the PoE LAN port of this AP.
−
Faster Speed (Auto Negotiation): This mode features a high transmission
rate but short transmission distance. Generally, this mode is
recommended.
−
Longer Distance (10 Mbps Full Duplex): This mode features a long
transmission distance but relatively low transmission rate (usually 10
Mbps).
− The 10 Mbps Full Duplex mode is recommended only when the Ethernet
cable that connects the PoE LAN port of the AP to a peer device exceeds
100 meters. In this case, the connected LAN port of the peer device must
work in auto-negotiation mode. Otherwise, the PoE LAN port of the AP may
not be able to properly transmit or receive data.
− Modifications to Ethernet mode take effect after you reboot the AP or
unplug from and plug into the port again.
To Next Page
Loading...
