ISCO 4230 - Page 170

4230 Flow Meter
Appendix B Programming Worksheets
B-2
8. D.O./ph Reading Interval: Continuous, 15 Sec, 30 Sec,
1Min, 2 Min, 5 Min
9. YSI 600 Reading Interval: Continuous, 15 Sec, 30 Sec,
1Min, 2 Min, 5 Min
10. Level Enable/Alarm: Hysteresis ________Feet (Or Meters)
11. Flow Rate Enable/Alarm Hysteresis _______Units______
12. Temperature Enable/Alarm Hysteresis ______Deg. F (C)
13. pH Enable/Alarm Hysteresis ________pH units.
14. D.O. Enable/Alarm Hysteresis ________ppm.
15. YSI-pH Enable/Alarm Hysteresis ________pH units.
16. YSI-D.O. Enable/Alarm Hysteresis ________ppm/mg./L
17. YSI-Conductivity Enable /Alarm Hysteresis_______mS/cm
18. YSI-Temperature Enable/Alarm Hysteresis______Deg.
19. Optional Outputs: 4-20 Ma Output, Serial Output, Alarm
Box, Mechanical Totalizer
20. Report Setup, Report A: Flow, D.O./pH, YSI 600, Sample
History, Flow Meter History
21. Level In Report: Yes, No
22. Flow Rate In Report: Yes, No
23. Rainfall In Report: Yes, No
24. pH or D.O. In Report: Yes, No
25. Temperature In Report: Yes, No
26. YSI 600 Data in Report: Yes, No
27. Sample History In Report: Yes, No
28. Flow Meter History In Report: Yes, No
29. Report Setup, Report B: Flow, D.O./pH, YSI 600, Sample
History, Flow Meter History
30. Level In Report: Yes, No
31. Flow Rate In Report: Yes, No
32. Rainfall In Report: Yes, No
33. pH or D.O. In Report: Yes, No
34. Temperature In Report: Yes, No
35. YSI 600 Data in Report: Yes, No
36. Sample History In Report: Yes, No
37. Setup Options: Status, Report Setup, LCD Backlight
38. LCD Backlight Mode: Time-out, Continuous, Off
39. Language: English, French, German, Spanish
40. Program Lock: On, Off
41. Select Option: Program, Setup. This time, select Program
and do the following (Program Section)
42. Units Of Level Measure: Ft., In, M, mm, Not Measured