ISCO 4230 - B.3 Parameter to Adjust; B.4 Reset Totalizer; B.5 Sampler Pacing; B.6 Sampler Enable

4230 Flow Meter
Appendix B Programming Worksheets
B-5
B.3 Parameter to Adjust 1. Parameter To Adjust: None, Level, pH, D.O., YSI 600
2. (Job Site only) Enter Current Level: __.____ Ft (or M).
Note: Installations generally use either the Isco parameter
probes or the YSI 600 Sonde, but not both. Use the follow-
ing menus for either the Isco probes or the YSI 600 Sonde.
Steps 3, 4, and 5 can be used for both 2 and 3-point pH cal-
ibrations.
3. Rinse Probe And Place In 4.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
4. Rinse Probe And Place In 7.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
5. Rinse Probe And Place In 10.0 pH Solution: Press Enter
When Stable __.____ pH (job site only)
6. (YSI 600 D.O. Calibration only): D.O. Standard, Absolute
Barometric Pressure, Altitude
7. Altitude Units Of Measure: Ft., M (D.O. probe only)___ (job
site only)
8. (D.O. only) Enter Altitude: Altitude = _______ Feet (or
meters, at job site only)
9. Wrap D.O. Probe In Moist Cloth: Press Enter When Stable:
__.____ MG/L (at job site only)
10. Conductivity Calibration Units: Ms/cm, Ppt__________
11. Place Probe In ______Ms/cm. (or ppt) Press Enter When
Stable: _______Ms/cm (at job site only)
12. YSI 600 Dissolved Oxygen Calibration: D.O. Standard,
Absolute Barometric Pressure, Altitude
B.4 Reset Totalizer 1. Reset Totalizer: Yes, No
2. Enable Totalizer ______CF (or other units)_______
3. Reset Sampler Enable Totalizer: Yes, No
B.5 Sampler Pacing 1. Sampler Pacing: Disable, (Volume), (Flowlink), Conditional
2. Sampler Pacing: Enter Pacing Volume __.____ CF
3. Condition: Level, Flow Rate, Rainfall, D.O., pH, Tempera-
ture, YSI pH, YSI D.O., YSI Conductivity, YSI Tempera-
ture
4. Condition: Greater Than, Less Than, Rate Of Change
5. Select Operator: Done, Or, And
6. Condition True Pacing Interval: Pace Every _____ Minutes.
7. Condition False Pacing Interval: Pace Every _____ Min-
utes.
B.6 Sampler Enable 1. Sampler Enable Mode: Disable, Enable, Conditional,
(Storm), (Flowlink)
2. Level: Greater Than __.____ Feet (or meters)
3. Rainfall Amount: __.____ Inches (other units)