ISHIDA Astra - Default PLU (P08); Default PLU

page 44 ASTRA • Operation Manual • Rev. 0124C
Chapter 4. Registration Mode
ENTER
Example: PLU No. “2222”
END
➝
➝
or
➜
➝
8
Note: Refer to Section 4.1 to enter the Registration mode.
ZERO
MODE
5
➝
2 2 2 2
ENTER
➜
4.9 Default PLU
PROCEDURES
1 Press the DOWN ARROW key ( ) until
the OPEN PLU menu (P08) appears or
key in “8” followed by the DOWN
ARROW key ( ) to enter the menu
directly.
2 Press ENTER key to enter the default
PLU Number menu (P08-00) to set the
default PLU number.
3 Key in PLU number and press the
ENTER key.
• After a transaction, the scale will return to the
default PLU instead of clearing to no PLU.
• Use the default PLU to bypass entry of a PLU for
each transaction.
• A different PLU may be recalled at any time to
override the default PLU during normal operation.
• To disable the default PLU, enter "0".
4 Press the END key to return to the
PLU menu (P01).
Press the MODE key to return to
normal operation mode after all
operations of Registration Mode are
completed.