CCI.TECU – Introduction
1.4 Active/passive mode
If only CCI.TECU is available on the tractor, it works automatically in active mode.
In active mode
1. CCI.TECU reads out the signal connector signals,
2, CCI.TECU calculates values for speed, power take off speed and 3-
point position and
3. CCI.TECU sends the calculated values for speed, power take off speed and
3-point position to all ISOBUS implements.
If the tractor has a Primary TECU or a TECU of higher priority is available that
provides the tractor information via the ISOBUS, CCI.TECU automatically switches
to passive mode.
In passive mode information which is available via the ISOBUS is shown, a
connection to the signal connector is only necessary if not all tractor information is
provided via the ISOBUS (see chapter 4.4)
1.5 Hectare counter
CCI.TECU offers a hectare counter as an additional function.
The hectare counter is used to record ground coverage, working time and the
track. Recording of ground coverage is performed by measuring the working route
and multiplying the adjustable working width.
6
To Next Page
Loading...