CCI.TECU – Commissioning
The signal connector according to ISO 11786 has the following sensor data
allocated:
Wheel speed sensor:
It emits a specific number of electrical signals in
proportion to the wheel rotation. As such, the
theoretical speed of the tractor can be calculated.
Ground speed sensor:
It emits a specific number of electrical pulses in
proportion to the distance already covered. As such,
the real speed can be calculated.
PTO sensor:
It emits a specific number of electrical pulses in
proportion to the power take off speed. As such, the
power take off speed can be calculated.
3-point hitch sensor:
It provides an output voltage which is proportional to
the current position of the 3-point hitch.
Note
On a terminal of hardware generation 1 (version 1.x), CCI.TECU in this version
can only evaluate the signals of one of the two speed sensors.
With a terminal of hardware generation 2 (version 2.x) both speed signals can be
used simultaneously (see chapter 4.3.3.3).
3.3 Installing the software
CCI.TECU is included in the scope of delivery of the CCI ISOBUS terminal, i.e.
installation is neither possible nor required.
Pos: 8 /CC -Iso bus/**** Seitenu mbruch **** @ 8\mod_1274446340522_0.doc @ 121469 @
9
To Next Page
Loading...