isobus VT50 - 3 Commissioning; Mounting the Terminal; Connecting the Terminal

To Next Page

To Previous Page

CCI.TECU – Commissioning

Pos: 5 /CC -Isobus/Aufbau @ 8\mod_1273585112215_6.doc @ 120207 @ 12223333333332

Pos: 7 /CC -Is obus/I nstal lati on @ 8\mod_1273570481145_6.doc @ 120033 @ 1223333

3 Commissioning

3.1 Mounting the terminal

For information, please refer to the chapter 5.1 Mounting the terminal in the

ISOBUS Terminal CCI 100/200 Operating Instructions.

3.2 Connecting the Terminal

3.2.1 Connecting to ISOBUS/power supply

Please refer to the information in the chapter 5.2.1 Connecting to ISOBUS/power

supply of the ISOBUS Terminal CCI 100/200 Operating Instructions.

3.2.2 Connecting to the signal connector

CCI.TECU evaluates the existing tractor information on the signal connector of the

tractor (speed, power take off speed, etc.) and transmits this information to all

ISOBUS implements.

A signal cable is required for connecting the terminal to the signal connector and

can be ordered using article number <ArtNummer Sig>.

Signal cable

To connect the terminal to the signal connector of the tractor, proceed as follows:

1. Connect the "Signal" interface on the terminal to the signal connector using the

signal cable.