isobus VT50 - CCI.TECU Troubleshooting; Terminal Errors and Solutions; Error Messages and Rectification

CCI.TECU – Troubleshooting
5 Troubleshooting
5.1 Terminal errors
The following overview shows possible terminal errors and how to solve them:
Error Possible cause Rectification
The terminal does not switch
on
• Terminal is not correctly
connected
• Check ISOBUS
connection
• Ignition is not switched
on.
• Start tractor.
The software of the connected
implement is not displayed
• Bus terminator missing • Check resistance
• Software is loaded,
however is not displayed
• Check whether the
software can be
manually started from
the terminal start menu
• Connection error when
uploading the software
• Check physical
connection
• Contact the implement
manufacturer's customer
service
5.2 Error messages
The following overview shows error messages in CCI.TECU, their possible cause
and how to rectify them:
Error Possible cause Rectification
Cannot delete tractor!
There is only one tractor or
you are trying to delete the
active tractor.
• There is only one tractor in
the list of tractors
• If you want to delete the
last tractor in the list, it is
not possible.
• The selected tractor is
currently active in the TECU
main view.
• Activate another tractor in
the TECU main view.
Invalid value!
Measured position exceeds
max. value.
The maximum position was not
measured during the 3-point
hitch calibration.
Carry out the 3-point hitch
calibration again.
Invalid value!
Measured position below min.
value.
The minimum position was not
measured during the 3-point
hitch calibration.
Carry out the 3-point hitch
calibration again.
36