VT50 – Troubleshooting
6.2 Error messages
The following overview shows error messages in the terminal, their possible cause
and how to rectify them:
Error Possible cause Rectification
Program cannot find a suitable
update file.
• Flash drive is not inserted
• Insert flash drive
• Update file is not available
on the flash drive
• Copy update file to the
flash drive
Process interrupted by error. Call service technician
Screenshot could not be
created.
Flash drive is not inserted Insert flash drive
Implement objects have been
rejected.
Error in the implement object
pool
Contact the implement
manufacturer
Connection to a WorkingSet
was broken.
Call service technician
Another VT #0 has been
identified in the network. The
VT cannot log on to the
network.
The terminal is set as the
primary terminal.
The terminal must be logged
on as a secondary terminal.
Program cannot find a suitable
update file.
• Flash drive is not inserted
• Insert flash drive
• Update file is not available
on the flash drive
• Copy update file to the
flash drive
To activate the new settings,
restart the terminal.
The terminal settings have been
changed.
Switch off the terminal and
then switch on again.
Note
Other error messages may be displayed on the terminal that are dependent on the
implement.
A detailed description of these possible error messages and troubleshooting can
be found to in the implement operating instructions.
Note
If the implement cannot be operated, check whether the stop switch is pressed.
The implement cannot be operated until the switch has been released.
62
To Next Page
Loading...