CCI.Cam – Introduction
Pos: 1 /CC -Is obu s/Ei nlei tu ng @ 8\ mod_1273561492335_6.doc @ 119978
1 Introduction
1.1 About these operating instructions
These operating instructions are intended as an introduction to the operation and
configuration of the CCI.Cam app. This app is preinstalled on your ISOBUS
terminal CCI 100/200 and can only be run from there. It is only with knowledge of
these operating instructions that accidental misuse can be avoided and fault-free
operation ensured.
These operating instructions must be read and understood prior to setting up the
software to avoid problems in the application.
1.2 Reference
These operating instructions describe the CCI.Cam Version CCI.Cam v4.
To query the version number of the CCI.Cam installed on your terminal proceed as
follows:
1. Press the home key to enter the main menu.
2. Press the "Settings" button (F1) in the main menu.
3. Select the tab Info and Diagnostics.
4. In the tab Info and Diagnostics press the button "Terminal".
5. Press the "Software" button on the touchscreen.
The version of the terminal software component is indicated In the
information field that is now displayed.
1.3 About CCI.Cam
CCI.Cam is used for visual implement monitoring by video camera. The app allows
the worker to keep an overview of his implement with up to 8 cameras and
supports the worker during complex working procedures.
Enhanced functions such as cyclical camera switching and flexible configuration of
the camera connections facilitates day-to-day working. The snapshot function
allows photos to be taken and stored on a flash drive.
Pos: 3 /CC -Isobus/Sicherheit @ 8\mod_1273562473695_6.doc @ 120017 @ 122222
4
To Next Page
Loading...