isobus VT50 - VT50 Operation; Switching On the Terminal

VT50 – Operation
5 Operation
5.1 Switching on the terminal
Note
Before switching on the terminal for the first time, check that the connections on
the device are properly and correctly positioned.
• Switch on the terminal using the "ON/OFF" button on the casing at the
bottom left. Press the button for approx. 2 seconds.
5.2 Entering values
Values must be entered, changed or selected for the configuration and use of both
the terminal and the connected implements.
The values are modified by using the so-called input dialogues. These dialogues
are shown above the current active operating screen. After modification the input
dialogue is closed and the user returns to the operating screen.
5.2.1 Buttons in Input Dialogues
By using the "OK" button, the newly set target value is accepted
in all input dialogues. The previous value is overwritten.
Alternatively, the scroll wheel can be pressed to accept the new
value.
By using the "ESC" button, the input is aborted in all input
dialogues. The previous value is maintained.
Alternatively, the "ESC" button can be pressed on the scroll
wheel to abort the action.
19