CCI.TECU – Operation
Note
If you select the signal connector as the signal source for the wheel speed sensor
or the ground speed sensor you must calibrate the speed or manually enter the
pulses per 100 metres.
More detailed information on speed calibration can be consulted in chapter 4.3.3.4.
Note
If you select the signal connector as the signal source for the 3-point hitch sensor
you must calibrate the 3-point hitch.
More detailed information on the 3-point hitch calibration can be consulted in
chapter 4.3.3.6.
Note
If you select the signal connector as the signal source for the PTO sensor you must
enter the pulses per revolution.
24
To Next Page
Loading...