ITEM C 1-Series - Serial Interface [X5]; USB Interface [X19]; UDP Interface [X18]; CAN Interface [X4]

Product description
Page 35
3.4.1 Serial interface [X5]
The RS232 protocol is mainly intended to be a parameterisation interface, but also allows the control of the item servo
positioning controller C Series.
3.4.2 USB interface [X19]
This interface, too, was mainly intended as a parameterisation interface, but it can also be used for controlling the item servo
positioning controller C Series.
3.4.3 UDP interface [X18]
The UDP communication enables the connection of the item servo positioning controller C Series to the Ethernet fieldbus
system. The communication via the UDP interface [X18] is realised with the aid of a standard cabling.
3.4.4 CAN interface [X4]
The CANopen protocol as per DS301 with application profile DSP402 is implemented.