COMPLEX RADIO CONTROL SYSTEM
With the throttle at idle position, move
the two sticks to the extreme positions
(the elevator fully up and the ailerons
with the rudder towards each another):
Motors should start spinning and after
3 seconds without applying throttle
they should stop. If the motors are not
spinning, check the "Minimum running throttle" parameter in the
„Configuration / Multicopter Settings” menu.
17. Before your first flight, it is necessary to test the stabilisation
reaction with the propellers, ideally when the model is mounted
on a test bench which allows rotation in only one axis. It is
necessary to ensure that the model in the Aerobatic or Sport
mode is able to maintain a constant direction at zero stick
movement and also to avoid undesirable oscillations.
16. Now lay the model on a flat surface - once the stabilisation is
initialized, the speed controllers usually respond by beeping. Try
arming the motors (still without the propellers attached):
18. Make your first flight in calm air on a grassy or other soft surface
with plenty of space. Start by arming the motors and lightly
adding throttle. Use small stick movements to make sure that the
receiver responds in correct direction of each axis and tries to
stabilise the model. If you experience any unexpected behavior,
be prepared to immediately lower the throttle and land.
15. In the „Configuration/Multicopter Settings” menu, test the
correct rotation direction of the motors according to the diagram
displayed on the top of the screen.
EN
21
To Next Page
