Version OS 1.0
12.2 Clear Pattern (2)
With this function you can clear the pattern edit buffer. The whole pattern is managed
in a temporary edit buffer as well. In order to clear it, first choose it.
Press (Shift/Cancel) and then (Step 2). Now the display shows:
Clear Pattern?
Just confirm with the (Enter) button, and the pattern in edit buffer gets erased. As
long you don’t store it, the old pattern in memory remains unchanged.
12.3 Store Pattern (3)
Press (Shift/Cancel) - all 16 step LEDs start to blink - then select (Step 3) = Store
Pattern. The display shows:
Store Patt OOO
Now you have the choice to either store immediately by pressing (Enter), or to store
the edits you have made to another location. This is basically a copy function because
the source pattern in the upper line will not be overwritten in this case (also you don't
have to make edits, just open the store pattern function on a pattern you wish to copy).
As soon as you turn the (Data) wheel or press the up/down buttons, the display shows
the destination:
Store to: OOO
OO1
The step and bank LEDs follow the destination pattern number.
If you press (Enter), the pattern gets stored to permanent flash memory.
The display monitors the progress of flash programming.
ALPHA BASE Operating Manual 101
To Next Page
Loading...
Need help?
General
