6.2.1.1 Pitc1 = M1 Pitch < 000- 127 >
This parameter controls the pitch of the first membrane oscillator M1 (F-OSC). The
range goes from about 25Hz to 14kHz.
Please note that the pitch is also a little affected by the settings of M1 Dampen and
both coupling parameters 1_2 Couplg and 2_1 Couplg. Because of the sensitive analog
circuitry, these values interfere with each other a little bit so that re-adjustment of
values may be neccessary to achieve a special sound.
6.2.1.2 Damp1 = M1 Dampen < 000-127 >
With the parameter M1 Dampen you change the decay of sound, meaning the Dampen
of F-OSC M1. If turned up, M1 fades longer and becomes a steadily vibrating oscillator.
A low value makes the F-OSC M1 decay very short.
6.2.1.3 Pitc2 = M2 Pitch < 000-127 >
This parameter controls the pitch of the second membrane oscillator M2 (F-OSC). The
range goes from about 25Hz to 14kHz. Other than that, the same qualities apply as
described in 4.1. M1 Pitch.
6.2.1.4 Damp2 = M2 Dampen < 000-127 >
By the parameter M2 Dampen you change the decay of sound, means the Dampen of F-
OSC M2. Other than that, the same qualities apply as described in 4.2. M1 Dampen.
ALPHA BASE Operating Manual 37
To Next Page
Loading...
Need help?
General
