Version OS 1.0
Now you can see and hear that the decay value changes when the sequencer comes
across the programmed steps. If you are still in Edit mode of this track and in sound
editing mode, the display shows the locked values jumping.
11.3.2.2 Setting Instrument Select as p-locks
It's even possible to p-lock an instrument selection.
This is a complex p-lock as the whole instrument with all parameters is recalled on a
step. Follow this list:
• Switch to Multi Mode = Click on Knob 12.
• Go right with the cursor to the number of the desired instrument you want to
change (see also 8.1.1 Selecting an Instrument in Multi Mode).
• Turn on (SEQ) if it wasn't before.
• Turn on Edit mode if it wasn't before .
• Press again (KIT/SEQ) so that you are in Kit/Instrument select menu.
• Now press and hold a desired step and turn the (Data) wheel, not a
parameter knob. The instrument selection gets recorded into that step.
• Do this with other steps
The instrument selection playback works even in Single Mode, though p-lock
programming is only possible in Multi Mode.
Please note that after clearing (SEQ) you would have to recall the preset again to have
the original instrument because the instrument recall is not updated automatically.
ALPHA BASE Operating Manual 97
To Next Page
Loading...
Need help?
General
