6.7 CONFIGURATION – USERS
Figure 9: Users
The “Users”-tab allows users to enable or disable access unit buses, set the paging priories between dierent buses and
enable or disable recording for paging events on individual buses. One bus may contain up to two 1601 and two 1603 access
units or up two 1605/1606 access units.
Each individual bus can be enabled or disabled. Disables buses will not trigger a general warning due to missing access units
on that parcular bus, so buses without connected access units should be disabled. The priority for each bus applies to pag-
ing messages, where 0 is the highest priority and increasing integers represent lower priories. A message with a lower pri-
ority cannot interrupt a message with higher priority. Recording can also be set up on the bus, controlling whether messages
shall be recorded in its enrety prior to playback.